晋城夹爪-苏州吉玛泰克-机械手气动夹爪

编程单个SB8F

在对传感器盒进行编程之前，请确保有线输入处于所需配置（开/关）以启用输出。按下AUTOSET按钮并按住3秒钟，机械手气动夹爪，直到READING红灯开始闪烁，然后松开。红灯（READING）闪烁表示微处理器正在读取和存储全部输入的状态。然后红灯熄灭，启用了输出。黄灯（STORED）指示启用输出。

Before programming the sensor box， make sure that the wired inputs are in the confguration (ON/OFF) desired to enable the output. Press the AUTOSET button and hold it down for  3 seconds until the READING red light starts fashing， then release it.The  red light (READING) fashing indicates that the microprocessor is reading and storing the state of all the inputs. Then the red light goes off and the output is enabled. Output enabling is indicated by the yellow light (STORED).

带有 3 个颚式钳的自动定心气动抓持器（TH 系列）

?双动作，机械夹爪，带可选弹簧（一般关闭或者一般开启） (3)。

?长行程或者短行程(1)。

?可通过螺丝紧固在前面(2)。

?高i效率的传动装置(1)。

?可选的类磁感传感器。

?FDA-H1 食品级润滑脂.

?Double acting with optional springs (normally closed or normally open) (3).

?Long stroke or short stroke (1).

?Possibility of front fastening with through screws (2).

?High efffciency force transmission (1).

?Optional magnetic or inductive sensors.

?FDA-H1 food-grade grease.

夹具订制

AGG可在机械手和模具间提供精i准的中心。

注塑模具内金属嵌件安放时尤其要注意这一点。

夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。

一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，

并与之接触。

AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，确保在压缩空

气 (NC)缺失时设备的正常运行。

AGG19-B 采用的是单动作复位弹簧(NO)。

Gripper for engagement

The AGG is used to provide a precise centering between the robot

and the mould.

This necessary when metal inserts must be p1aced in the

mould， before the p1astic injection.

The gripper AGG…-B is fitted on the EOAT， while the steel bushing

AGG…-C is fitted on the mould.

Once the robot has approached the mould， the gripper is

pressurized， thus it closes and engages the bushing.

AGG21-B and AGG30-B are double-acting with a safety spring to

keep the gripper engaged even without compressed air (NC).

AGG19-B is single-acting with reset spring (NO).