保定夹爪-吉玛泰克自动化-气动夹爪

? 传感器位于后部位置以及抓持区域占用空间更小的新理念。

? 可选磁性传感器 (1)。

? 只有在抓持物品时，保定夹爪，传感器才打开。

? 带有弹簧开口的单动式驱动器。

? 高抓持力。

? 配有几个安装附件 (2)。

? 钢质颚式钳。

? FDA-H1 食品级润滑脂。

? 防止进入微小异物 (3)。

? 重型末端行程。

2-jaw self-centering angular pneumatic sprue

gripper， series DD

? New concept with retracted sensor and smaller dimensi0ns in

the grip area.

? Optional magnetic sensors (1).

? The sensor is ON only when something is gripped.

? Single acting with spring opening.

? Very high closing force.

? Several mounting accessories (2).

? Steel jaws.

? FDA-H1 food-grade grease.

? Protection against the entry of small foreign bodies (3).

? Heavy-duty end-strokes.

夹具订制

AGG可在机械手和模具间提供精i准的中心。

注塑模具内金属嵌件安放时尤其要注意这一点。

夹具AGG...B 安装在EOAT上，钢管 AGG...C 安装在模具上。

一旦机械手向模具靠近，夹具在压力的作用下逐步向钢管靠近，

并与之接触。

AGG21-B 和 AGG30-B 采用的是双动作安全弹簧，确保在压缩空

气 (NC)缺失时设备的正常运行。

AGG19-B 采用的是单动作复位弹簧(NO)。

Gripper for engagement

The AGG is used to provide a precise centering between the robot

and the mould.

This necessary when metal inserts must be p1aced in the

mould，爪夹制作， before the p1astic injection.

The gripper AGG…-B is fitted on the EOAT， while the steel bushing

AGG…-C is fitted on the mould.

Once the robot has approached the mould，机械夹爪， the gripper is

pressurized， thus it closes and engages the bushing.

AGG21-B and AGG30-B are double-acting with a safety spring to

keep the gripper engaged even without compressed air (NC).

AGG19-B is single-acting with reset spring (NO).

SBMS/SBMS-E - 从模块

每个单独的从模块均可以连接单个传感器。它由内部总线连接（由主模块提供）供电，并触发两个固态继电器的换向：基于传感器输出的常开触点和常闭触点。两个选择器可用于配置传感器信号输出（PNP/2线或NPN）和逻辑（正向或反向）。该模块还有两个用于诊断的LED指示灯。

Each individual slave module enables the connection of a singlesensor.

It is powered from the internal bus connection (provided by themaster module) and triggers the commutation of two solid staterelays: a NO contact and a NC contact based on sensor output.

Two selectors are available to conffgure sensor signal output(PNP/2 wires or NPN) and logic (direct or reverse).The module also has two LED indicators for diagnostics.